Toshiba GR200 Series Instruction Manual page 1349

GOOSE receiving block (GOSUBBLK)
(ii)
This is used for receiving or rejecting GOOSE subscription information from another IED for
testing bad reception. See Chapter
Test flag cancel (S-TestFlagCancel)
(iii)
Test flag in the communication packet will be removed unconditionally, when On is set for
setting [Test flag].
Test for all communication (TestFlag-EN)
(iv)
Setting [TestFlag-EN]=On allows to set test flags at all communication protocol (see Chapter
User interface: Test-submenu
Test for relay application
14.4.2
Auto monitoring function (A.M.F)
(i)
Issuing alarms will be blocked when Off is set for [A.M.F]. For the content about the monitoring
function, see Chapter
Test of cold load protection (CLP-Test)
(ii)
STATE0 or STATE3 will be selected temporally, if STATE0 or STATE3 is set for setting [CLP-
TEST]. See Chapter
ZS, ZG test (ZS-Test.CTRL, ZS-Offset.CTRL, ZS/ZG-Test.XAngle)
(iii)
ZS-Test.CTRL
Setting [ZS-Test.CTRL]=On allows not to operate Zmin feature. For more information about
the Zmin, see Chapter
ZS-Offset.CTRL
Setting [ZS-Offset.CTRL]=Non-Offset allows not to operate offset feature during the test.
ZS-Test.XAngle, ZG-Test.XAngle
Setting [ZS-Test.XAngle]=On allows to take fixed knee characteristic during the test.
Thermal overload function test (THM-Test, THM-IP)
(iv)
Setting [THM-Test]=On allows to have a test value for the pre-load current (Ip). The Ip value
is discussed in Chapter
SOTF test (SOTF-Test)
(v)
Setting [SOTF-Test]=On allows to generate the cold load condition mandatorily for testing,
which is discussed in Chapter
Communication protocol: IEC 61850 communication
).
Automatic supervision function
Relay application: Cold load protection
Relay application: Distance protection
Relay application: Thermal overload function
Relay application: Switch on to fault
- 1328 -
.
for more detail.
.
.
.
GRZ200 (Soft 031 & 032)
6F2S1915 (0.46)
.