Sony STR-DN1080 Manual page 177

No sound is output from the speakers connected to this receiver when [Bluetooth Mode] is set to
[Transmitter].
In [Transmitter] mode, this receiver can send audio to up to 1 device.
Hint
You can set the transmission data rate for LDAC playback using [Wireless Playback Quality] in the
[Bluetooth Settings] menu.
If you connect to this receiver from your smartphone while [Transmitter] is selected and no other
BLUETOOTH receiver is connected to this receiver, the setting automatically switches to [Receiver]
and you can listen to the sound from your smartphone via this receiver.
You can also switch between [Receiver] (RX) mode and [Transmitter] (TX) by pressing BLUETOOTH
RX/TX on the remote control.
Depending on the BLUETOOTH receiver, you can adjust the volume of the BLUETOOTH receiver
from this receiver when [Transmitter] is selected.
[207] Adjusting Settings
Checking the BLUETOOTH device list (Device List)
You can check a list of the paired and detected BLUETOOTH receivers such as headphones
when [Bluetooth Mode] is set to [Transmitter]. You can perform pairing with detected devices
from the list.
Select [Setup] - [Bluetooth Settings] from the home menu.
1
Select [Device List].
2
Hint
Select [Scan] to refresh the list.
[208] Adjusting Settings
Setting the BLUETOOTH Standby mode (Bluetooth
Standby)
You can set the BLUETOOTH Standby mode so that this receiver can be controlled by a
BLUETOOTH device even when this receiver is in standby mode.
Select [Setup] - [Bluetooth Settings] from the home menu.
1
Select [Bluetooth Standby].
2
Bluetooth Settings
Bluetooth Settings