Motorola KEY 3000 User Manual page 51

Perform Initial
Programming
(continued)
ASN Operation
Chapter 3 Performing Initial Programming
System Dependent Parameters
The parameters and settings in this category
must be set depending on the particular system
in which the KVL 3000 will be operating.
Create the MDC ID (OTAR Only)
ID is used when the KVL 3000 communicates
with a KMC (in an Advanced SECURENETt
OTAR system). Enter this unique ID as follows:
1. Navigate to the CONFIG menu, then
select ID. The following screen will
appear:
KVL MDCID IS
EMPTY
EDIT
2. Press to select EDIT. The following
screen will display. Using the Del/Shift
key, back out" the digits and enter the
desired 4 digit ID. Do not use all 0's. Do
not use any F's. Do not use E as the first
character.
ENTER
KVL
MDCID
>0001J
3. Press the Enter key to save the ID.
The MDC
CLEAR
3-15