Checking Fluid Levels; Using The Gauge Bar - Toro 03781 Operator's Manual

8

Checking Fluid Levels

No Parts Required
Procedure
1. Check the rear axle lubricant level before the engine is
first started, refer to Checking the Rear Axle Lubricant
in Drive System Maintenance.
2. Check the hydraulic fluid level before the engine is first
started, refer to Checking the Hydraulic Fluid Level in
Operation.
3. Check the engine oil level before and after the engine is
first started, refer to Checking the Engine Oil Level in
Operation.
9

Using the Gauge Bar

Parts needed for this procedure:
1 Gauge bar
Procedure
Use the gauge bar to adjust the cutting unit. Refer to
the Cutting Unit Operator's Manual for the adjustment
procedures (Figure 24).
1. Gauge bar
2. Height adjusting screw
3. Nut
21
Figure 24
4. Holes used for setting
Groomer HOG
5. Hole not used