Premaintenance Procedures; Removing The Hood; Lubrication; Greasing The Bearings And Bushings - Toro 03781 Operator's Manual

Premaintenance
Procedures

Removing the Hood

1. Release hood latches (Figure 42) and pivot open the
hood.
Figure 42
1. Hood latch (2)
2. Remove the cotter pins securing the rear hood brackets
to the frame pins and lift off the hood.

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that must be lubricated
regularly with No. 2 General Purpose Lithium Base Grease.
If the machine is operated under normal conditions, lubricate
all bearings and bushings after every 50 hours of operation or
immediately after every washing.
The grease fitting locations and quantities are as follows:
•
Brake shaft pivot bearings (5) (Figure 43)
•
Rear axle pivot bushings (2) (Figure 44)
39
Figure 43
Figure 44