Installing The Transport Wheels; Checking Fluid Levels - Toro 04022 Operator's Manual

3
Installing the Transport
Wheels
Parts needed for this procedure:
Transport wheels (Optional Transport Wheel Kit,
2
Model 04123)
Procedure
1. Push kick stand down with foot and pull up on
handle support until kick stand has rotated forward,
over center (Figure 7).
1. Kick stand
2. Press wheel locking clip toward the center of wheel
and slide wheel onto hex shaft (Figure 8).
Figure 7
1. Locking clip
3. Rotate wheel back and forth until it slides completely
onto axle and locking clip is secured in groove on
axle shaft.
4. Repeat procedure on opposite side of machine.
5. Inflate the tires to 12-15 psi.
6. Carefully lift up on handle support to release kick
stand.
4

Checking Fluid Levels

No Parts Required
Procedure
1. Check the engine oil level, refer to Checking the
Engine Oil Level.
2. Check the transmission fluid level, refer to Checking
the Transmission Fluid Level.
11
Figure 8