NEC SL1000 Features And Specifications Manual page 21

ISSUE 1.0
Conditions
• If a user enters a code that exceeds the 16 digit limit, the system ignores the Account Code Entry.
• If the system has Account Codes disabled, the digits dialed (e.g.,
port as part of the number dialed.
• If using Forced Account Code with single line telephone you need a VRS to get the prompts to enter
the Forced Account Code.
• When you use Forced Account Code on only toll calls, and you dial a local call, you hear a beep.
• The timer set in 21-01-14 is applied to toll calls and local calls.
• Speed Dial - System/Group/Station bins can contain stored Account Codes. They can be prevented
from being displayed using Program 20-07-04.
• To simplify Account Code Entry, store the Account Code (e.g.,
press the key instead of dialing the codes.
• Account Codes appear on the SMDR report (even if they are hidden on the telephone display).
• Do not use an asterisk within a PBX/CTX access code when using Account Codes. The
the trunk to stop sending digits to the central office until another
• Account Codes for incoming calls not available for single line telephones.
• When using Forced Account Codes (Unverified) for toll calls only, the station follows the timer setting
in Program 21-01-14 for all calls.
• System Account codes are bypassed when using DISA trunks. If a user calls in via a DISA trunk, the
user is not required to enter an account code.
• Emergency number data will be defined in program 21-24-01. First digit of dialing data should be
same as trunk access code.
Default Settings
Disabled
System Availability
Terminals
Any Station
Required Component(s)
VRS for Forced Account Codes for Single Line TelephonesNone
Related Features
Abbreviated Dialing/Speed Dial
Automatic Route Selection (ARS/F-Route)
PBX Compatibility/Behind PBX
Station Message Detail Recording
Guide to Feature Programming
Program Number
14-01-11 Basic Trunk Data Setup - Account Code Required
15-07-01 Programmable Function Keys
Account Code Key (code 50)
20-06-01 Class of Service for Extensions
Features and Specifications Manual
Program Name
1234 ) appear on the SMDR re-
* *
1234 ) in a One-Touch Key. Just
* *
is entered.
*
Default
1
Refer to Programming Manual.
All extension port = Class 1
SL1000
A
, causes
*
1-13