Conference, Remote - NEC SL1000 Features And Specifications Manual

ISSUE 1.0
Description
The Remote Conference feature enhances the Conference feature by allowing outside parties to dial a
Remote Conference pilot number and a Conference Group number to connect to a Conference
call.The conference circuits on the CPU are used to join each party to the conference. A maximum of
16 conference participants is possible for one Conference. However, the conference call cannot be
split over the CPU's conference blocks. This could limit the number of participants if other conference
circuits are in use.
A maximum of 4 simultaneous Remote Conference calls is possible. The conference call is password
protected so that any user joining the conference would be required to enter a password before being
connected.
• One terminal or trunk needs one conference channel to participate in the conference.
• The conference call cannot be split over the CPU's two conference blocks, limiting the number of
conference participants to 16.
Conditions
None
Default Setting
Not defined
Related Features
Barge-In
The Barge-In feature cannot be used for an extension user on a Remote Conference call.
Call Forward
The Remote Conference pilot number can not be set as the destination for Call Forward.
Hold
Using Hold while on a Remote Conference call is not possible.
Transfer
Calls cannot be transferred to the Remote Conference session.
Guide to Feature Programming
Program
Number
11-19-01 Remote Conference Pilot Number Setup - Maximum Channels
14-01-02 Basic Trunk Data Setup - Transmit Level
14-01-03 Basic Trunk Data Setup - Receive Level
14-01-04 Basic Trunk Data Setup - Transmit Gain Level for Conference
and Transfer Calls
Features and Specifications Manual

Conference, Remote

Program Name
SL1000
Default
Refer to Programming Manual.
32 (0dB)
32 (0dB)
32 (0dB)
1-139
C