Lenovo Moto Z4 Service And Repair Manual page 83

Lenovo Moto Z4
Level 2 – Service and Repair Manual
5. If the Moto Display/Inlay Removal Fixture
(MR-M2-001) currently holds the Inlay
Removal Insert Removal Insert (MR-M2-
001-043), skip to step 10.
6. Use the 3 mm Allen Wrench to remove
the 2 center screws holding the Display
Removal Insert in place (if present).
Remove the Insert.
7. Orient the Rear Inlay Removal Insert in
relation to the Display/Inlay Removal
Fixture as shown. Place the Insert in the
Display/Inlay Removal Fixture.
8. Use the 3 mm Allen Wrench on the 2
center screws to tighten the Rear Inlay
Removal Insert into position.
9. Follow preheating steps described on
page 19.
NOTE
Begin this step after removal from the Hot Plate
or oven, before the phone starts to cool off.
10. Slide the phone into the Removal Fixture
as shown. Center the phone in the
Fixture.
PAGE 83
Lenovo Confidential Restricted:
Do not share without consent from Lenovo