Top Carrier Assembly - Lenovo Moto Z4 Service And Repair Manual

Lenovo Moto Z4
Level 2 – Service and Repair Manual

Top Carrier Assembly

Description
Stingray FRU MB NA 4+128G SS
Stingray FRU MB NA VZW 4+128G SS
Stingray RearCVR FLSHGRY Etching NA
Stingray RearCVR FLSHGRY Etching VZW
Stingray RearCVR WHT Etching VZW
Stingray FRU RearCVR FLSHGRY
Stingray FRU RearCVR WHITE
Stingray P Sensor OP1 FPCA,15.56x10.44mm
AU,SPKR,TBD,8OHM,BX,1.5W at 8OHM,800Hz,9
HDW,SCR,STL,Screw_ M1.4x0.30x2.50mm_Plum
HDW,SCR,STL,Screw,M1.4X2.8,Plum
1. Use rolling pressure to connect the
Proximity Sensor BtB Connector to the
Main PCB.
2. Place the Top Carrier into the pocket on
the Front Housing as shown.
3. Press down on the Top Carrier until it
snaps into place.
4. Use the Torque Driver and the T3 Torx Bit
to tighten the 7 T3 Torx Machine Screws
to 1.0 ± 0.10 in-lb (0.11 ± 0.01 N∙m).
PAGE 157
Reference #
3
5
10
11
16
Lenovo Confidential Restricted:
Do not share without consent from Lenovo