Pioneer 1200 Maintenance Service Manual page 280

17
TORQUE CONVERTER
Drive Clutch Assembly, Continued:
6. Install the moveable face assembly (14) onto the shaft of the fixed face assembly (7). See following
CAUTION.
CAUTION
• To avoid damaging the spiral back-up rings, be very careful when installing the moveable
face.
Figure 17-10 Remove Idler Bearing
Insert pin
through
primary weight,
then install
wave washer
onto pin.
PRIMARY
WEIGHT
PIN
Figure 17-12 Install Pin and Washer
6.1. Rotate the moveable face assembly clockwise while installing it onto the shaft.
6.2. Install the retaining ring (3) (Figure 17-7, Page 17-8).
7. Install the primary weights on the mounting pins (Figure 17-12, Page 17-10).
Page 17-10 2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual
PRESS RAM
IDLER BEARING
BEARING PULLER
FIXED FACE
ASSEMBLY
WAVE
WASHER
Wave washer
installed on same
side as small pin.
Use a scribe to remove
spiral back-up rings from both
sides of fixed face assembly.
Figure 17-11 Spiral Back-up Rings
Install the secondary
weight onto pin.
SECONDARY
WEIGHT
PIN
Figure 17-13 Install Secondary Weight
Drive Clutch