Pioneer 1200 Maintenance Service Manual page 225

FUEL SYSTEM
2.10. Roll the floormat from underneath the dashboard and drill out the one bottom pop rivet (30) that
secures the air intake shield (29) to the floorboard.
2.11. Use a putty knife or other thin bladed device and gently pry apart the adhesive strip that holds the
shield to the vehicle frame. See following NOTE.
NOTE: It may become necessary to re-form the shield prior to installation.
2.12. Remove the shield (29) from the vehicle frame.
2
Figure 14-9 Compound Steering Joint
2.13. Drill out the pop rivet (24) securing the top of the intake duct to the floorboard (Figure 14-10,
Page 14-17).
2.14. Remove the air box assembly. See Air Box Removal on page 14-11.
2.15. Lift air box assembly off the intake duct. Be careful that the intake seal on the bottom of the air box
assembly is not dislodged in the process.
2.16. Pull the intake duct forward, and out of the vehicle.
3. Pioneer 1200SE:
3.1. Remove the air box assembly (Figure 14-11, Page 14-18). See Air Box Removal on page 14-11.
3.2. Lift rear floor mat on the drivers side and drill out pop rivets (27) and remove strap (14).
3.3. Cut the wire tie holding Forward/Reverse cable and choke cable to the air duct under the vehicle.
3.4. Slide the air duct toward the front of the vehicle and down until it clears the chassis plate.
2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual
1
Choke and Air Intake System
Page 14-13
14