Pioneer 1200 Maintenance Service Manual page 249

MC012C-AS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK
4. Detach all wires, hoses, etc. connecting the powertrain to the vehicle.
4.1. Disconnect the carburetor vent tube from the carburetor (Figure 16-9, Page 16-7) .
Figure 16-9 Carburetor Vent Tube
4.2. Disconnect the air intake hose from the carburetor (Figure 16-10, Page 16-7).
4.3. Disconnect impulse line from fuel pump (Figure 16-11, Page 16-7) .
CLAMP
Figure 16-10 Air Intake Hose
4.4. Disconnect the fuel line from the carburetor. Temporarily push the disconnected end of the line onto
the impulse line fitting of the fuel pump (Figure 16-14, Page 16-9) .
5. Remove the differential lock cable.
5.1. Place differential lock handle in the disengaged direction.
5.2. Use a pair of pliers and apply pressure to the locking tabs of the cable end (1) where it attaches to
the differential lock handle mounting bracket (Figure 16-12, Page 16-8) . Pull the differential lock
cable toward the rear of the vehicle to disconnect the cable from the bracket (Figure 16-12,
Page 16-8) .
5.3. Rotate the cable connector toward the driver side of the vehicle to disconnect the cable from the dif-
ferential lock lever (1) (Figure 16-13, Page 16-8) .
2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual
CLAMP
Unitized Transaxle Removal
IMPULSE LINE
Figure 16-11 Impulse Line
16
Page 16-7