Pioneer 1200 Maintenance Service Manual page 193

ELECTRICAL COMPONENTS: FE400 ENGINE
17. Attach the engine to the bottom of the engine mounting plate using the bolts (1), washers (2), and nuts
(5). Tighten hardware to 21 ft-lb (28.4 N·m). See Figure 13-5, Section 13, Page 13-6.
18. Tighten the two engine body bolt nuts (6) to 17 ft-lb (23.1 N·m).
19. Install the engine and transaxle assembly. See Unitized Transaxle Installation, Section 16,
Page 16-16. See following CAUTION.
CAUTION
• Make sure wire harness is routed and secured away from the muffler.
10
Remove
Figure 12-26 Remove Fan Housing
1
2
CAP
SPARK PLUG
Figure 12-28 Clean Grommet
2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual
6
9
5
8
3
4
5
7
6
8
12
13
11
Figure 12-27 Black Wire And Ignition Coil
6
0.012 Inch
(0.304 mm)
Figure 12-29 Mount Ignition Coil Using Feeler Gauge
12
Ignition Coil
10
Page 12-25