Pioneer 1200 Maintenance Service Manual page 116

10
PERIODIC MAINTENANCE
Engine Oil and Filter Change, Continued:
Figure 10-6 Compress Snubber Downward
NOTE: An oil drip guard can be used to prevent excess oil from dripping into the engine base plate. Use
an empty quart or 1 liter container and cut the bottom off at an angle, then slide the open area of
the container up and under the oil filter prior to removing. Position the port of the plastic container
so oil will be directed into the oil pan (Figure 10-7, Page 10-6). Or, make a drip guard by folding a
piece of cardboard, thin metal, or plastic under the oil filter forming a channel to direct the filter port
oil into the drain pan.
Dispose of used oil according to the environmental laws and regulations for your area.
10. Use a clean rag and wipe the oil filter mounting bracket surface clean where the oil filter gasket seats.
11. Install a new oil filter (CCI P/N 1016467). Apply a light coat of white lithium NLGI Number 2 grease (Dow
®
Corning BR2-Plus or equivalent), or new engine oil to the rubber seal of the filter before installation. This
will help seal the filter to the oil mounting bracket. See following NOTE.
NOTE: Use only Club Car oil filters (CCI P/N 1016467) designed for this engine.
Figure 10-8 Replace Engine Oil Filter
Page 10-6 2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual
COMPRESS
DOWN
SNUBBER
BRACKET
SNUBBER
Coat Rubber Seal
OIL DRIP GUARD
DRAIN PAN
Figure 10-7 Remove Engine Oil Filter
Figure 10-9 Add Engine Oil
Engine Oil
USED OIL FILTER