Pioneer 1200 Maintenance Service Manual page 209

FE400 ENGINE
Flywheel Installation
See Engine Installation on page 13-9.
Ignition Coil Inspection and Repair
See Test Procedure 16, Section 11, Page 11-34.
Ignition Coil Installation
1. Installation is the reverse of removal.
2. Tighten the two bolts (3) and use a bronze feeler gauge to adjust the ignition coil air gap to 0.012 inch
(0.304 mm) (Figure 13-9, Page 13-7).
3. Tighten the two ignition coil bolts to 30 in-lb (3.4 N·m).
Remove.
Figure 13-6 Flywheel Housing
4
Figure 13-8 Flywheel Nut Removal
2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual
Loosen
Remove.
5
7
Ignition Coil and Flywheel
2
1
Figure 13-7 Ignition Coil
3
0.012 inch
(0.304 mm)
Figure 13-9 Adjust Ignition Coil Air Gap
13
3
Page 13-7