FUEL SYSTEM
2
3
4
7
8
10
12
NOTE: Make sure the intake hose is not twisted during installation.
21. Turn fuel shut-off valve (on fuel tank) to the ON position (Figure 14-21, Page 14-27 and Figure 14-22,
Page 14-28).
22. Connect the battery cables, positive (+) cable first, and tighten terminals to 20 ft-lb (27.1 N·m). Coat ter-
minals with Battery Terminal Protector Spray (CCI P/N 1014305).
23. Test drive the vehicle.
ENGINE CONTROL LINKAGE
See General Warning, Section 1, Page 1-1.
GENERAL INFORMATION
It is important that the accelerator pedal, governor linkage, and throttle adjustments are done correctly and in
the proper sequence. See following CAUTION.
2003 Pioneer 1200/1200SE Gasoline Vehicle Maintenance and Service Manual
A
1
5
CAUTION: DO NOT REMOVE VALVE/SPRING
FROM FLOAT. TO DO SO WILL DAMAGE SPRING.
If spring looks
6
C
like this...
9
11
or this...
then adjust
spring to look
like this by...
Figure 14-3 Changing the Main Jet
Engine Control Linkage
STEPS 2 AND 3
Drain carburetor over
a catch basin by turning
bowl drain screw (11)
counterclockwise
2 to 3 turns.
B
STEP 4
Mark carburetor
and corresponding
position of fuel bowl.
D
holding float firmly...and...
rotating valve counterclockwise
to seat spring in seat of float bowl.
Check for
coil located in
groove above
both ears.
Check for
spring seated
in recess of
float body.
14
Page 14-5