Cme Error Mobile Equipment Error; Chsr Hscsd Parameters Report - Nokia 30 GSM Connectivity Terminal At Command Manual

1
<str> string type USSD string (when <str> parameter is not given, network is not
interrogated):
-
-
-
-
-
-
<dcs>
15.3.10

+CME ERROR Mobile equipment error

Format
+CME ERROR: <err>
Defined values
<err> See Error values section
15.3.11

+CHSR HSCSD parameters report

Format
+CHSR: <rx>, <tx>, <aiur>,
<coding>
Further user action required (network-initiated USSD-Request, or
further information needed after
If <dcs> indicates that GSM 03.38 default alphabet is used
If the TE character set is other than "HEX" (refer to the Select TE
command)
Character Set +CSCS): the Nokia 30 converts the GSM alphabet
into the current TE character set according to the rules of GSM
07.05, Annex A
If the TE character set is "HEX": the Nokia 30 converts each 7-bit
character of the GSM alphabet into two IRA character long
hexadecimal numbers (e.g. character Π (GSM 23) is presented as
17 (IRA 49 and 55))
If <dcs> indicates that an 8-bit data coding scheme is used: the
Nokia 30 converts each 8-bit octet into two IRA character-long
hexadecimal numbers (e.g. octet with integer value 42 is presented
to the TE as two characters 2A (IRA 50 and 65))
GSM 03.38 Cell Broadcast Data Coding Scheme in the integer
format (default 0)
Description
Given instead of ERROR when +CMEE=1 or =2 and the error is related to the
ME or network operation
Description
Given when +CHSR=1. Result code transmission is done after possible service
(+CR), error control (+ER), and/or compression (+DR) reporting but before
possible TE-TA rate (+ILRR) reporting and before the intermediate result code
CONNECT is transmitted.
mobile-initiated operation)
91/107