Facto; S25 Detect Dtr Change Time; S Dsr Signal Behaviour; K Select Flow Control - Nokia 30 GSM Connectivity Terminal At Command Manual

DTE-DCE rate. If enabled, the intermediate result code is transmitted after any error control
or data compression reports are transmitted and before any final result code (i.e. CONNECT)
is transmitted.
4.2 DE FACTO

4.2.1 S25 Detect DTR change time

Command
Set S25=<n>
Read S25?
The S25 command sets the time in seconds for reacting to the DTR signal change. The
value 255 inhibits the signal change recognition. See also the &D command.
4.2.2 &S DSR signal behaviour
Command
Set &S[0]
&S1
The &S command is ignored, the DSR is always ON.
4.2.3 &K Select flow control
Command
Set
&K[0]
&K3
&K4
The &K command changes the same setting as the +IFC. The use of +IFC is recommended.
Response <n> values
0..255 (default 0)
<n> 000..255
Description
Always on
No effect
Description
No flow control
Hardware flow control (RTS/CTS)
Software flow control (XON/XOFF)
11/107