S6 Pause Before Blind Dialling; S7 Connection Completion Timeout; S8 Comma Dial Modifier Time; S10 Automatic Disconnect Delay - Nokia 30 GSM Connectivity Terminal At Command Manual

6.1.8 S6 Pause before blind dialling

Command
Set S6=<n>
Read S6?
The S6 command is ignored. The implementation is according to GSM 07.07 section 6.18.

6.1.9 S7 Connection completion timeout

Command
Set S7=<n>
Read S7?
The S7 command sets the number of seconds allocated to the completion of call answering
or an originating procedure before the procedure is aborted. Implementation is according to
GSM 07.07 section 6.18.

6.1.10 S8 Comma dial modifier time

Command
Set S8=<n>
Read
S8?
The S8 command specifies the time in seconds that the DCE should pause during the
signalling of call-addressing information to the network (dialling) when a "," (comma) dial
modifier is encountered in a dial string of the D command. Implementation is according to
GSM 07.07 section 6.18.

6.1.11 S10 Automatic disconnect delay

Command
Set S10=<n>
Read
S10?
The S10 command sets the time in tenths of a second that the Nokia 30 will remain
connected to the line after it has indicated the absence of the received line signal. If the
received line signal is detected before the time specified in the S10 expires, the Nokia 30
Response <n> values
2..10
002 002
Response <n> values
0..255 (default 60)
<n> 000..255
Response <n> values
0..255 (default 2)
<n> 000..255
Response <n> values
0..255 (default 100)
<n> 000..255
21/107