Connecting The Communication Cable; Figure 4-1 Connecting The 10Base5 Transceiver Cable To The Module - Hitachi S10mini User Manual

4 FL.NET MODULE WIRING PROCEDURES

4.1 Connecting the Communication Cable

(1) Connecting the 10BASE5 transceiver cable
When the module number selector switch is set to 0 or 1, the module uses the 10BASE5
interface connector to establish communication with the other modules.
Ensure that the 10BASE5 cable is connected as shown in Figure 4-1.
For communications with 10BASE5, it is also necessary to supply power from a 12-VDC
external power source. For external power source connection, see "4.3 Power Supply
Wiring."
LQE502 for
LQE502

Figure 4-1 Connecting the 10BASE5 Transceiver Cable to the Module

LQE500 FL.NET
TX
MODU
RX
No.
LER
10BASE
-5
10BASE
-T
12V
GND
FG
Retainer
Module-end
connector
Connect the cable to the 10BASE5
interface connector.
10BASE5 interface cable
Push up the retainer in
the direction of the arrow
and then insert the
connector into its position.
Cable-end
connector
Lock post
4-2
After the connector is
inserted into position,
push down the retainer in
the direction of the arrow.