8 APPENDIXES
(9) Insulating the terminator and connector
The connectors (junction connector and L-type connector) must be insulated as indicated in
Figures 8-61 and 8-62.
Coaxial connector
(N-type)
Coaxial connector (N-type)
The terminators (T-NP male and T-NJ female) must be insulated as indicated below:
• Install an insulation sleeve (black) (I-NPC) over the male T-NP.
• Install an insulation sleeve (black) (I-NJP) over the female T-NJ and insulation tape it
down.
(10) Applicable terminator (terminal resistor)
For the terminator recommended for use with the FL.NET module, see "8.5.1 Ethernet
component list."
Insulation tape
Linear sleeve
Figure 8-61 Junction Connector Insulation
Figure 8-62 L-type Connector Insulation
Insulation sleeve cuttings
Insulation tape
L-type connector
Insulation sleeve cuttings
Transceiver NJ connector
8-60
Insulation sleeve
Coaxial cable