(7) Transceiver (connector type) installation
Same as explained under "(6)-(a) Transceiver (tap type) installation."
(a) Applicable transceiver
For the transceiver recommended for use with the FL.NET module, see "8.5.1 Ethernet
component list."
(b) Installation procedure
① Finishing the coaxial cable
For the procedure for mounting the coaxial connector on a coaxial cable, see item (5),
"Installing the coaxial connector."
② Mount the coaxial connector on the transceiver body. Screw down the transceiver body
to prevent it from being disconnected. Also, insulate the terminator by installing a
rubber boot over it.
Coaxial connector
Figure 8-58 Installing the Connector-type Transceiver
(c) Setting the SQE switch
See "Table 8-16 SQE Switch Settings."
P-type terminator
Connector-type transceiver body
8-57
8 APPENDIXES
Rubber boot