Hitachi S10mini User Manual page 191

(6) The item whose setup has been changed is displayed in a different color.
Self-node
(7) If the node number to be displayed is not found on the window, click the
buttons to shift the display.
▼
▼
▼
(8) After completing the setup, click the
controller used is S10V). To cancel the setup, click the
The data of the self-node (Node No.1 in the above figure) is displayed in shadow form and the
setup cannot be changed. Change it on the Self-node setup or [Self-node information] window
(see "5.6.1 Self-node information").
If the FL.NET system is running in online mode, clicking the
Write button if the type of the controller used is S10V) causes the FL.NET module to
automatically isolate itself from the network and have the parameters written to the
actual target machine. Upon completion of the writing, the FL.NET module will
automatically join the network again according to the written parameters.
5.6.4 Joining other nodes information
Function: Monitor the information on other nodes that join the network, and set PCs allocation.
For using this function, it is a prerequisite that the PCs is connected to the PC by cable.
Operation: The procedure is shown below.
(1) When the FL.NET system is running in online mode, choose [Main] or [Sub] from the
[Module] menu in the [FL.NET] or [[S10V] FL.NET] window.
(2) Select the [Network] menu.
(3) The [All Networks] icon and each node No. icon (red or blue) connected to the network are
displayed. The red node No. icon indicates the self-node. The blue node No. icon indicates
other node connected to the network.
When the setup has
been changed, its
color changes.
OK button (or the
Cancel
5-139
5 USER GUIDE
▲
▲
▲
Write button if the type of the
button.
OK button (or the
and