Huawei AR500 Series Hardware Description page 325

Huawei
AR500&AR510&AR531&AR550&1500&AR2500
Industrial Switch Routers
Hardware Description
5
7
9
11 USB interface (host)
Indicator Description
Figure 3-55
Issue 10 (2019-03-06)
RESET button
NOTE
This button is used to reset the router.
l To reset the system, press the button.
l To restore the factory settings, hold down
the button for a period longer than 3
seconds and shorter than 10 seconds.
l Holding down the button for 10 seconds
or longer will switch from the default
CON mode to the RS232 mode or from
RS232 to CON mode.
Resetting the router will interrupt services.
Exercise caution when deciding to press this
button.
Power jack
NOTE
l The router supports Huawei
Integrated Power Adapter
Industrial AC Power
l Use a DC power cable to connect the
router to an external power source.
PoE power jack
PoE power jack
NOTE
The PoE power jack connects to a
PoE Power Adapter to provide power for
PDs (such as IP phones, WLAN APs, and
cameras) connected to GE interfaces of the
router.
shows the indicators on the AR509G-L-D-H router.
Copyright © Huawei Technologies Co., Ltd.
6 Two SIM card slots
NOTE
l The router supports double-card single-
l If only one SIM card needs to be
8 LTE antenna interface
4.3 24 W
or 4.5 60 W
Module.
10 Ground point
NOTE
To protect the router from lightning and
interference, reliably ground the router using
4.8 100 W
a
-
-
standby, and SIM1 is the default master
card.
installed, install it in slot SIM1.
6.8 Ground Cable.
3 Chassis
314