Drive Controller Replacement - GE T2100 Service Manual

Drive Controller Replacement

Connectors
(plugs)
Revision A
Assembly/Disassembly: Drive Controller Replacement
1. Turn the power switch off, disconnect the power cord from the wall
outlet, and remove the shroud.
2. Remove the 2 resistor mounting nuts.
3. Disconnect all connectors from the drive controller.
4. Remove the 4 nuts from the drive controller mounting bracket and
remove the mounting bracket and drive controller from the GE
T2100 Treadmill.
5. Remove the 4 nuts from the drive controller fastening points.
6. Remove the drive controller and replace with a new drive controller
in reverse order.
Resistor Mounting Nuts
7. Calibrate the GE T2100 Treadmill. See
10."
GE T2100 Treadmill
2021403-031
Drive controller mounting bracket.
2 mounting nuts on top, and 2
underneath the drive controller.
Drive controller
fastening points (4)
"Self-Calibration"
049
on page 3-
7-21