Drive Controller X1 Pin Descriptions - GE T2100 Service Manual

Drive Controller X1 PIN descriptions

7-22
Assembly/Disassembly: Drive Controller Replacement
Follow this diagram when wiring the X1 connection. Tighten each
terminal to a torque of 0.5–0.6Nm (4.4–5.3 lb-in).
PIN
R2 & R1 White wires going to the resistor. These wires can be inverted.
W Blue wire going to the drive motor.
V Red wire going to the drive motor.
U Black wire going to the drive motor.
L3 Not used.
L2 Black wire going to the L2 terminal on the power board.
L1 Black wire going to the L1 terminal on the power board.
NC Not used.
Gnd Orange-Yellow wire earth/ground going to the motor. Can be inverted with
the other Gnd.
Gnd Orange wire earth/ground going to the ground terminal on the power
board. Can be inverted with the other Gnd.
GE T2100 Treadmill
2021403-031
R2
R1
W
V
U
L3 – NC
L2
L1
NC
Gnd
Gnd
Description
061
Revision A