GE T2100 Service Manual page 42

Procedure
Is the unit level and stable.
!
Is the floor under the unit smooth and with no loose
!
tiles?
Check the drive belt tension and tracking
See "Drive Belt Adjustments"
specific tension and tracking tolerances.
Check Emergency Stop (ESTOP) Switch
Check Handles
Refer to "Double-Check Handles"
Communicate with Host
Can Host control elevation and speed?
!
Noise and Vibration
Vibration
!
Rattling or Growling
!
Thumping
!
Squealing or Grinding
!
Squeaking
!
3-16
Installation: Functional Checkout
Indicate
Pass/Fail
on page 7-16 for
on page 3-17.
GE T2100 Treadmill
2021403-031
If Failed, perform the following:
If unit is not level, adjust.
Relocate the GE T2100 Treadmill.
1. Adjust the drive belt tension and tracking.
See "Drive Belt Adjustments"
16.
2. Call tech support.
1. If belt does not stop, make sure
emergency stop switch is connected to
back of the GE T2100 Treadmill.
2. Call tech support.
Tighten handle fasteners.
1. Check that interface cable is properly
connected.
2. Replace Interface cable.
3. Use the GE T2100 Treadmill Diagnostic
Utility (TDU) to help troubleshoot the
problem. See "GE T2100 Treadmill
Diagnostic Utility (TDU)" on page 6-9.
See "Location of Major Sub-Assemblies"
page 7-4 to identify these assemblies.
1. Check drive belt and walking belt tension.
See "Walking Belt Tracking and Tension
Adjustment" on page 4-5.
2. Check for loose bolts and broken welds.
3. Check the fly wheel.
4. Check the drive pulley on motor.
5. Make sure the roller assembly bolts are
tight.
1. Check for loose bolts.
2. Check lithium grease on elevation racks.
3. Check drive motor and elevation motor.
Check drive belt and walking belt tension.
See "Walking Belt Tracking and Tension
Adjustment" on page 4-5.
1. Check drive motor and elevation motor.
2. Check elevation rack.
1. Check for split walking board.
2. Check drive motor and elevation motor.
Indicate
Pass/Fail
on page 7-
on
Revision A