Check Ge T2100 Treadmill Level; Leakage Tests - GE T2100 Service Manual

Check GE T2100 Treadmill Level

Leakage Tests

3-12
Installation: Equipment Assembly
Self-Calibration Routine
a. The GE T2100 Treadmill checks the functionality of the elevation
limit switches and the potentiometer by rising to the maximum
height limit switch.
b. The GE T2100 Treadmill sets the elevation parameters by
descending to the minimum height limit switch and then rising
again to the maximum height limit switch.
c. The GE T2100 Treadmill descends to 10% grade and revolves the
walking belt at 3.2 km/h (2 mph) for 30 seconds.
d. The GE T2100 Treadmill stops the walking belt and descends to
0% grade.
NOTE
Before you check the GE T2100 Treadmill level, make sure that it
has been moved to its final destination.
1. Use the controlling equipment to verify the GE T2100 Treadmill
elevation is 0.0%.
2. Check the GE T2100 Treadmill level with a carpenter's level.
3. If the GE T2100 Treadmill is uneven, adjust the feet at the rear of
the GE T2100 Treadmill until it is level.
4. If you cannot level the GE T2100 Treadmill safely, move it to another
location.
The leakage tests are safety tests to ensure that the equipment poses no
electrical health hazards. Use the table below to determine which tests
apply to the unit under test and the maximum allowable leakage
currents. For international leakage limits, refer to the internal standards
agencies of that particular country.
If the unit under test fails the leakage tests, do not allow the customer to
use the equipment. Call Tech Support for assistance. (See the "How to
Reach Us" page in the front of the manual.)
GE Medical Systems Information Technologies recommends that you
perform these tests:
Before applying power for the first time
"
Whenever internal assemblies are serviced
"
NOTE
The accuracy of the leakage tests depends on a properly-wired wall
outlet. Do not proceed until you verify the integrity of the power
source.
GE T2100 Treadmill
2021403-031
Revision A