Install Emergency Stop Switch - GE T2100 Service Manual

Install Emergency Stop Switch

3-8
Installation: Equipment Assembly
NOTE
The emergency stop switch must be installed and the ESTOP cable
plugged in to the GE T2100 Treadmill connection panel for the GE
T2100 Treadmill to operate. If the ESTOP is not installed, the GE
T2100 Treadmill will not operate.
1. Attach the two clamp pieces to the assembled, latching emergency
stop switch.
Emergency Stop
Switch Assembly
Handrail
Clamp
2. Position the clamps around the GE T2100 Treadmill front handrail
and secure with the supplied screw and nut. The emergency stop
switch can be mounted in different locations and positions based on
customer preference.
3. Connect the cable from the emergency stop switch to the connection
on the GE T2100 Treadmill's rear connector panel. (See
Panel" on page 2-7 for connection locations.)
4. Use the cord clips to attach the cable along the front handrail and
secure the excess cable.
GE T2100 Treadmill
2021403-031
Cable
047
"Connection
Revision A