Setting Items - Mitsubishi Electric MELSEC Q Series Reference Manual

2 SYSTEM CONFIGURATION

2.1.2 Setting items

(1)
Network module switch
Parameter setting on GX Developer
2 - 2
Table 2.1 lists the setting items on the master module of the remote master station
(MR) and the parameter setting items on GX Developer.
Table 2.1 Remote master station setting items
Setting items
STATION NO.
MODE
Setting the number of Ethernet/CC IE/MELSECNET cards
Network type
Starting I/O No.
Network No.
Total stations
Group No.
Mode
Common parameters
Supplementary setting
Station specific parameters
Refresh parameters
Valid module during other station access
Interlink transmission parameters
Routing parameters
: Always set,
1: Default values are not set in LX/LY. Set the refresh parameters.
2: Default values are preset for LB/LW.
The CPUs other than the Universal model QCPU may operate even if refresh
parameters have not been set.
For the operation and precautions, refer to Section 5.1.5 (3).
3: Refer to the Q Corresponding MELSECNET/H Network System Reference
Manual (PLC to PLC Network) (SH-080049).
Remote master station (M
0
MELSECNET/H
(Remote master station)
1
: Default setting, : Set as needed,
MELSEC-Q
) Reference
R
Section 4.2.1
Section 4.2.2
Section 5.1.1
Section 5.1.2
Section 5.1.2
Section 5.1.2
—
Section 5.1.2
Section 5.1.3
Section 5.1.4
—
2 Section 5.1.5
Section 5.1.6
—
3
: No need to set
2 - 2
2