Mode Button - Huawei RP100 Commissioning Manual

HUAWEI RP100&RP200 Room Presence
Commissioning Guide

8.1 MODE Button

The MODE button provides three functions, as listed in
Table 8-1 Functions of the MODE button
No.
1
2
3
You can restore the TE40 to its default settings through the web interface.
When the TE40 is running, log in to its web interface, choose System Settings > Installation
> Restore Default, and enter the TE40's SN in the displayed dialog box.
When the TE40 operates properly, press and holds the MODE button for about 10 seconds to
restore the default settings and restarts the TE40. After the restoration, the default TE40 IP
address is 192.168.1.1.
Figure 8-1 Restore Default dialog box
Issue 01 (2015-02-12)
NOTE
If the TE40 is used in a conference or being upgraded, it will not go to sleep after you press the MODE
button. Instead, an error message will be displayed on the remote controlled UI.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
To...
Restore the TE40 to its
default settings
Enter the bootrom system
Place the TE40 in sleep mode
or wake it up
8 Appendix-Physical Buttons
Table 8-1.
You...
Press and hold the MODE
button for 10s or more when
the TE40 is operating
properly.
Press and hold the MODE
button for 3s or more when
the TE starts powering on.
You can then use the TE40's
upgrade tool to upgrade the
TE40 using the bootrom
system.
Press the MODE button
when the TE40 is operating
properly.
91