Huawei PowerCube 5000 User Manual page 143

PowerCube 5000
User Manual (SmartLi 100Ah)
Figure 9-13 Removing an NIM01C3
Step 5 Remove the SIM card from the SIM card slot of the NIM01C3, and insert it into the SIM card
slot of the new NIM01C3. Skip this step if no SIM card is installed.
Step 6 Place the new NIM01C3 at the entry to the appropriate slot in the monitoring unit subrack,
and push the NIM01C3 until its front panel is flush with the front panel of the monitoring unit
subrack.
Step 7 Push the handle inwards until it is engaged, and then tighten the screws.
Figure 9-14 Installing an NIM01C3
Step 8 Connect the signal cables to the original positions on the NIM01C3 panel.
Step 9 Disconnect the ground cable for the ESD wrist strap, and remove the ESD wrist strap and
ESD gloves.
----End
Follow-up Procedure
Pack the removed component and have it sent to the local Huawei warehouse.
Issue 02 (2020-03-17)
The NIM01C3 must be installed in the original position (upper slot). Otherwise, it cannot work properly.
Copyright © Huawei Technologies Co., Ltd.
9 Parts Replacement
135