Faq - Huawei VS-EC-H24R User Manual

VS-EC-H24R&H28R&H29R
User Guide

PTZ: Acronym for Pan, Tilt, Zoom. PTZ cameras are motor driven systems that
allow the camera to pan left and right, tilt up and down and zoom in and out.

USB: Acronym for Universal Serial Bus. USB is a plug-and-play serial bus
standard to interface devices to a host computer.
B.2 FAQ
Why does my DVR make a beeping sound after booting
The possible reasons for the warning beep on the DVR are as follows:

There is no HDD installed in the DVR.

The HDD is not initialized.

HDD error.
To cancel the beeping sound and use the DVR without HDD, enter the Exception
Settings interface. For detailed information, see Chapter Handling Exception.
Why does the DVR seem unresponsive when operating with the IR remote control
Please check:

The batteries are installed correctly in the remote, making sure that the polarities of
the batteries are not reversed.

The batteries are fresh and are not out of power.

The remote has not been tampered with.

There are no fluorescent lamps in use nearby.
Why does the PTZ seem unresponsive
If the PTZ seem unresponsive, please check:

The RS-485 cable is properly connected.

The dome decoder type is correct.

The dome decoder speed configuration is correct.

The dome decoder address bit configuration is correct.

That the main board RS-485 interface is not broken.
Why is there no video recorded after setting the motion detection
If there are no recorded video after setting the motion detection, please check:

The recording schedule is setup correctly by following the steps listed in
Configuring Record/Capture Schedule.

The motion detection area is configured correctly (See Configuring Motion
Detection).

The channels are being triggered for motion detection (See Configuring Motion
Detection).
Issue 04 (2013-06-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
B Appendix
238