Toro Groundsmaster 3300 Series Operator's Manual page 36

Rotating the Cutting Unit to the
T Position
RANSPORT
Perform this procedure to rotate the cutting unit from
the S position to the T
ERVICE
1. Release the cutting-unit latch from the tie-down
bracket (Figure 34) by slightly rotating the cutting
unit slightly forward (refer to
pulling the latch handle forward.
2. Slowly rotate the cutting unit down until the pin
contacts the lift-arm plate (A in
Figure 33
position.
RANSPORT
Figure 32) and
Figure 34
Figure 35).
g298276
1. Lift-arm plate
3. Use your foot to press down on the cutting unit,
then pull out on the pin (B in
cutting unit settle into the T
4. Insert the height-of-cut pins through the
height-of-cut plates and chains.
g298277
36
Figure 35
2. Pin
Figure 35) to let the
position.
RANSPORT
g298288