Toro Groundsmaster 3300 Series Operator's Manual page 35

Figure 30
1. T position
RANSPORT
Rotating the Cutting Unit to the
S Position
ERVICE
Perform this procedure to rotate the cutting unit from
the T position to the S
RANSPORT
WARNING
If you leave the key in the switch, someone
could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the switch and do not
start the engine with the cutting unit in the
S position.
ERVICE
1. Park the machine a level surface.
g258473
2. S position
ERVICE
position.
ERVICE
2. Press the lift switch to raise the cutting unit to
the T
RANSPORT
3. Engage the parking brake, shut off the engine,
and remove the key.
4. Remove the pins from the height-of-cut plates
(Figure 31).
1. Height-of-cut pins
5. Rotate the cutting unit
latch engages with the tie-down bracket
33).
WARNING
The cutting unit is heavy.
Use assistance when you lift the cutting
unit.
35
position.
Figure 31
2. Height-of-cut plates
(Figure 32) so that the
Figure 32
g258474
(Figure
g298275