Setup - Toro Groundsmaster 3300 Series Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Description
No parts required
Rear wheel
Lug nut
No parts required
Right lift arm
Left lift arm
Large pin
Bolt (3/8 x 2-3/4 inches)
Nut (3/8 inch)
Small pin
Sensor bracket
Carriage bolt
Bolt (3/8 x 1-1/4 inches)
Grease fitting
No parts required
Tie-down bracket
Bolt (3/8 x 3-1/4 inches)
Nut (3/8 inch)
Seat Kit (ordered separately; refer to
your authorized Toro distributor)
Steering wheel
Cover
Bumper
Bolt (3/8 x 2-3/4 inches)
Bolt (3/8 x 3-1/4 inches)
Nut (3/8 inch)
No parts required
Attachment (ordered separately; refer to
your authorized Toro distributor)
Bolt (5/16 x 2 inches)
Nut (5/16 inch)
No parts required
No parts required
CE Kit (ordered separately; refer to your
authorized Toro distributor)
No parts required
Qty.
Remove the machine from the shipping
–
container.
2
Install the rear tires (Model No. 31902
only).
8
Remove the front tires (Model No.
–
31902 only).
1
1
2
2
6
Install the lift-arm assembly (Model No.
31902 only).
2
1
2
2
2
Install the front tires (Model No. 31902
–
only).
1
Install the tie-down bracket (Model No.
2
31902 only).
2
1 Install the seat (Model No. 31902 only).
1
Install the steering wheel (Model No.
31902 only).
1
1
2
Install the bumper (Model 31902 only).
4
6
Connecting the battery (Model No.
–
31902 only).
1
Install the attachment.
2
2
–
Check the fluid levels.
–
Check the tire pressure.
Installing the CE Kit (for use in
1
CE-compliant countries).
Adjust the weight-transfer pressure (if
–
needed).
10
Use