Connection Assignment And Switch Position; Jumper Position For The Switch Threshold Values Of The Binary Input Bi 2 - Siemens 7XV5654-0BA00 Manual

NOTE
i
i
Tighten the mechanical connections of the fiber-optic cables with ST connectors carefully and only hand-
tight. Do not use any tools for this!
Push the mechanical ST connectors carefully with the lug on the side into the slot of the device connection
and then lock the ST connectors in place with a short clockwise rotation.
Comply with the prescribed bending radius when routing fiber-optic cables.
Terminals X5
Connection
X5
X5
Terminals X6 for the Load Disconnecting Relay Outputs
Connection
X6
X6

Connection Assignment and Switch Position

2.2.2
2.2.2.1 9-Pole D-Sub Socket X1 with 2 Electrical Outputs
The socket X1 of the Sync-Transceiver provides 2 electrical signals (24 V) on 2 semiconductor outputs. The
pinout is identical to the assignment of Port A of the SIPROTEC 4 devices or Port G of the SIPROTEC 5 devices.
For channel 1, the pins 1 and 3 are assigned and, for channel 2, the pins 4 and 8 are assigned.
Table 2-1
Pin
1
2
3
4
5
6
7
8
9
2.2.2.2

Jumper Position for the Switch Threshold Values of the Binary Input BI 2

Table 2-2
Jumper
7
X100
X100
7 (Boldface = Factory setting)
Accessories, Sync Transceiver, Optical/Electrical Converter for Time Synchronization, Manual
C53000-G9050-C168-1, Edition 09.2019
Meaning
Binary input BI 2 (L+)
Binary input BI 2 (L-)
Meaning
Load disconnecting relay output, channel 2 (L+)
Load disconnecting relay output, channel 2 (L+ switched)
Pinout of the 9-Pole D-Sub Socket
Channel 1, reference potential (DC output: 24 V)
Channel 1, switch output, 0 V (GND)
Channel 2, switch output, 0 V (GND)
Channel 2, reference potential (DC output: 24 V)
Switch Threshold Values of the Binary Input BI 2
Position
1-2
2-3
Meaning
Unused
Unused
Unused
Unused
Unused
Switch threshold value
Approx. 17 V
Approx. 70 V
Device Structure
2.2 Device Connections
Description
1
2
Description
1
2
17