Defined Values; Cgsms-Set Message Bearer Domain; Command Syntax - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification

6.15.3 Defined Values

<index>: integer value, which indicates the position in the storage.
<stat>: message type:
0
1
2
3
4
<fo>: depending on the command or result code: first octet of 3GPP TS 23.040
SMS-DELIVER, SMS-SUBMIT (the default value is 17), SMS-STATUS-REPORT, or
SMS-COMMAND (the default value is 2) in integer format.
<mr>: message-reference.
<toda>: Type-of-Destination-Address.
<length>: integer value, which indicates the number of bytes of PDU data.
<pdu>: protocol data unit. Its format is the same as defined in section "Message list
command".
<oa./da>: originating address/Destination address. Same as defined in SCA. Total
2–12Otects. Therefore, the longest address in the OA segment contains 20 digits.
<scts>: Service-Centre-Time-Stamp.
<data>: data unit to send.
The other parameters can be found in GSM 07.05.
Note:
6.16 +CGSMS–Set Message Bearer Domain

6.16.1 Command Syntax

Command
+CGSMS=<service>
+CGSMS?
+CGSMS=?
Issue 04 (2013-01-28)
"REC UNREAD" received unread message (i.e. new message)
"REC READ" received read message
"STO UNSENT" stored unsent message (only applicable to SMS)
"STO SENT" stored sent message (only applicable to SMS)
"ALL" all messages (only applicable to +CMGL command)
If the message doesn‟t exist, the READ command will return OK.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>+CGSMS:
<service><CR><LF><CR><LF>OK<CR><LF>
<CR><LF>+CGSMS: (list of supported <service>s)
<CR><LF><CR><LF>OK<CR><LF>
Short Message Service Commands
99