Cmgf- Set Message Format; Command Syntax; Description; Defined Values - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
1: Supported (default value).
Note:
6.2 +CMGF– Set Message Format

6.2.1 Command Syntax

Command
+CMGF[=<mode>]
+CMGF?
+CMGF=?

6.2.2 Description

The SET command is used to set the format of the short message. The format has
two modes, and depends on the <mode> parameter. The two modes are: PDU mode
and TEXT mode. The TEXT mode is unable to display Chinese. The format of
message in PDU mode, refers to +CMGS command.
The READ command is used to return the current mode selection.
The TEST command returns the applicable <mode> values.

6.2.3 Defined Values

<mode>:
0: PDU modes (default value)
1: TEXT mode
If no <mode> is included, it is equivalent to the effect that the <mode> is 0.
Note:
Issue 04 (2013-01-28)
Command AT+CNMA requires <service> is set to 1.
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>+CMGF: <mode><CR><LF>
<CR><LF>OK<CR><LF>
<CR><LF>+CMGF: (list of supported <mode>s)<CR><LF>
<CR><LF>OK<CR><LF>
In TEXT mode, when choose GSM 7 bit coding mode, only support GSM 7 bit basic characters,
not support GSM 7 bit extended characters.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Short Message Service Commands
65