Defined Values; Autoanswer-Auto Answer; Command Syntax; Description - Huawei MU509 At Command Interface Specification

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification

9.11.3 Defined Values

<value>:
0: Disable automatic answering (default value).
1–255: Enable automatic answering after the specified number of rings
Note:
9.12 ^AUTOANSWER–Auto Answer

9.12.1 Command Syntax

Command
^AUTOANSWER=<n>
^AUTOANSWER?

9.12.2 Description

Autoanswer only corresponds to CS call.
This command is used to


The SET command is used to set whether MS can answer a call automatically or the
number of rings before the incoming call is auto-answered.
The READ returns the current value of parameter <n>.
For CS incoming call:



<n> is stored in NV when the command executed, and is restored from NV when
booted up.
Issue 04 (2013-01-28)
Value of S0 will restore to default when module was reset.
MS can answer a call automatically.
The function of auto-answer will be reserved after module reset.
Both S0 and ^AUTOANSWER equal 0, the incoming call will not be
auto-answered.
Either S0 or ^AUTOANSWER not equal 0, the incoming call will be
auto-answered after S0 or ^AUTOANSWER rings which not equal 0.
Both S0 and ^AUTOANSWER not equal 0, the incoming call will be
auto-answered after the smaller one of S0 and ^AUTOANSWER rings.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Possible response(s)
<CR><LF>OK<CR><LF>
<CR><LF>^AUTOANSWER:<n><CR><LF><CR><LF>O
K<CR><LF>
Call Control Commands
138