Huawei MU509 At Command Interface Specification page 78

HUAWEI MU509 HSDPA LGA Module
AT Command Interface Specification
<TP-PID>: protocol ID. The default value set by TE when sending the message is
00000000. If the transmitting address is an E-mail, the TE should fill in
00110010=0x32.
<TP-DCS>: while sending the message, the TE selects the TP-DCS mode.
Table 6-7 The description of setting the bit number
bit7~bit6(
while
sending
the
message,
the TE
selects
the
TP-DCS
mode)
bit7~4
(while
sending
the
message,
the TE
does not
Issue 04 (2013-01-28)
bit5
bit4
00, while
sending
bit3~2
the
(messag
message
e code
, the TE
format)
selects
this
value.
bit1~0
(messag
e type, its
value is
selected
by TE
according
to the
user‟s
options)
1100 and
1101
(GSM 7
bit3
bit code),
1110
(uncomp
bit2
ressed
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Short Message Service Commands
If TE sets bit5 to be 0, it indicates no
0
message is compressed.
If bit5 is 1, it indicates the sent message is
1 compressed, and TE does not select this
value.
If TE sets bit4 to be 0, it indicates that bit1
0
and bit0 are reserved, and the value is 00.
If bit4 is 1, it indicates that bit1 and bit0 have
the meaning of message type (The message
type depends on the user‟s settings. If the
1
message type is set by the user, TE sets bit4
to be 1, e.g. set class 1 or class 2).
0
GSM 7 bit default code
0
0
8bit data
1
UCS2 code mode. When the user inputs
1
Chinese characters, the TE will select this
0
value.
Class 0, provided to the interface to display
0
and reply that the SC has received but not
0
stored it.
0 Class 1, stored to the MS (i.e., NV), or stored
1 to the SIM card when the MS is full
Class 2, for special use of SIM. After the
1 message is stored, the storage state will be
0 replied to the SC. If the SIM card is full, the
SC failure and the reasons will be reported.
Class 3, stored to the TE. When the MS
1 receives the message, but has not
1 transmitted it to the TE, it will give a response
to the SC.
The message wait prompt function is invalid.
Currently, the functions that require
0
prompting, e.g. enforcement message,
E-mail and voice mail, are not supported.
1 Activate the message waiting prompt function
0 Reserved bits, which make no sense.
78