Installing The Hopper Extension Kit - Toro ProPass 200 Operator's Manual

Figure 8
1. Socket bracket
2. Route and secure the electrical wiring from the
battery to the electrical plug bracket
Figure 9
1. White wire (brass)
2. No wire silver (silver)
3. Feed the wiring through the socket bracket and
install the black rubber grommet over the wiring
(Figure 9).
4. Bolt the socket to the socket bracket using the
bolts (1/4 inch).
5. Connect the red wire (power) to the positive
post on the battery, then connect the black wire
(ground) to the negative post on the battery.
g013261
(Figure 9).
g013262
3. No wire (brass)
4. Black wire (brass)
3
Installing the Hopper
Extension Kit
Parts needed for this procedure:
1 Hopper extension (front)
1 Hopper extension (rear)
9 Bolt
9 Flange nut
Procedure
1. Remove the hopper extensions from the box
and identify the front and the rear
and Figure 11).
1. Front hopper extension (showing hole orientation)
1. Rear hopper extension (showing hole orientation)
2. Using the hardware provided, attach the hopper
extensions to the hopper. Place the nuts on the
outside of the hopper.
11
(Figure 10
Figure 10
Figure 11
g013263
g013264