Setup - Toro ProPass 200 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
Media and Additional Parts
Description
Operator's Manual
Declaration of Conformity
Note:
Determine the left and right sides of the machine from the normal operating position.
Description
Hopper guard
Button head bolt (1/4 x 5/8 inch)
Locknut
Power harness
Socket bracket
Socket bracket, heavy
Carriage screw
Flange nut
Screw
Flange nut
Hopper extension (front)
Hopper extension (rear)
Bolt
Flange nut
Bolt
Flange nut
Intermediate wire harness
On/off pendant
Handheld remote
AA batteries
Magnetic bracket
Screws, small
Controller mount assembly
Wireless remote assembly
Qty.
1
3
3
1
1
1
2
2
2
2
1
1
9
9
6
6
1
1
1
4
1
6
1
1
Qty.
1 Read before operating the machine.
1 Ensure regulatory compliance.
8
Use
Set up the machine base model.
Install the power harness.
Install the hopper extension kit.
Mount the hopper to the tow chassis.
Connect the intermediate wire harness.
Connect the on/off pendant (Model
44701 only).
Assemble the handheld remote (Model
44751 only).
Mount the wireless remote (Model
44751 only).
Use