Using The Storage Stand - Toro ProPass 200 Operator's Manual

1. Jack stands on Truckster Direct Connect

Using the Storage Stand

1. Park the work vehicle in the storage spot for the
machine.
Note:
The storage spot must be a hard and
level surface.
2. Disconnect the electrical connection from the
work vehicle.
3. Disconnect the machine hydraulic lines from the
work vehicle.
4. With the work vehicle in neutral gear, engage
the parking brake and start the engine.
5. Using the vehicle lift cylinder, raise the front of
the machine high enough to install the front
storage stand legs.
6. Shut off the engine.
WARNING
Working on the machine while it is on
the storage stand could result in serious
injury or death.
Do not climb under or perform work on
the machine while it is on the storage
stand.
7. Insert the front storage legs and the rear jack
stands into the machine tubes and secure them
with the locking pins
Figure 48
(Figure 49).
g013338
1. Rear jack stands
2. Front storage legs
8. Using the vehicle lift cylinder, lower the front of
the machine until the front storage stand legs
begin to touch the ground.
9. Raise the 2 rear storage jack stands until the
pressure is off the mounting pins that secure the
machine cross tube to the Workman frame.
10. Remove the rear lynch pins, hitch pins, and
washers
1. Hitch pin, washers, and lynch pin
11. With 1 hand, hold the lift cylinder. With the
other hand, remove the lift cylinder's locking pin
(Figure 51).
36
Figure 49
3. Locking pin
(Figure 50).
Figure 50
g013777
g013228