Toro ProPass 200 Installation Instructions Manual
Hydraulic power pack, top dresser
Hide thumbs
Also See for ProPass 200:
- Service manual (130 pages) ,
- Operator's manual (48 pages) ,
- Operator's manual (44 pages)
Advertisement
Quick Links
Hydraulic Power Pack
ProPass 200 Top Dresser
Model No. 44713—Serial No. 315000001 and Up
This product complies with all relevant European directives. For details, please see the Declaration of
Incorporation (DOI) at the back of this publication.
The engine exhaust from this product contains chemicals known to the State of
California to cause cancer, birth defects, or other reproductive harm.
Battery posts, terminals, and related accessories contain lead and lead
compounds, chemicals known to the State of California to cause cancer and
Safety
Safety and Instructional Decals
Safety decals and instructions are easily visible to the operator and are located near any area
of potential danger. Replace any decal that is damaged or lost.
1. Warning—do not touch the hot surface.
1. Cutting/dismemberment hazard of hand, conveyor—stay
away from moving parts, keep all guards and shields in
place.
© 2018—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
reproductive harm. Wash hands after handling.
115-2047
119-6844
Register at www.Toro.com.
WARNING
CALIFORNIA
decal115-2047
1. Warning—no step
decal119-6844
Form No. 3392-986 Rev B
Installation Instructions
119–6807
Original Instructions (EN)
All Rights Reserved *3392-986* B
Printed in the USA
decal119-6807
Advertisement
Related Manuals for Toro ProPass 200
Summary of Contents for Toro ProPass 200
- Page 1 Form No. 3392-986 Rev B Hydraulic Power Pack ProPass 200 Top Dresser Model No. 44713—Serial No. 315000001 and Up Installation Instructions This product complies with all relevant European directives. For details, please see the Declaration of Incorporation (DOI) at the back of this publication.
- Page 2 decal119-6829 119–6829 1. Read the Operator's Manual. 2. Maximum load of 907 kg (2000 lb) results in an axle weight of 1,530 kg (3320 lb) and a tongue weight of 145 kg (320 lb ). 3. Empty hopper has an axle weight of 599 kg (1320 lb) and a tongue weight of 48 kg (105 lb).
- Page 3 Installation CAUTION Before attempting to install the ProPass - 11 HP Hydraulic Power Pack, ensure that: • The ProPass is located on firm level ground. • The ProPass jack stand is lowered. • All external hydraulic and electrical power sources are disconnected. •...
- Page 4 De-burr each hole. onto the ProPass hitch tube. Ensure that the engine mount brackets straddle the hitch tube Ensure that the ProPass Hitch Tube is clean and (Figure 5 and that the rear of the engine mount free from dirt or debris. plate is approximately 25 mm (1 inch) from the Unpack the engine assembly.
- Page 5 g013860 Figure 7 1. Hitch tube 2. Mounting bolts (2) Adjust the engine mount bracket so that it is tight to the hitch. Fully tighten the two bolts securing the engine mount brackets to the engine mounting plate (Figure Check that the engine mounting plate is level and fully tighten the 2 bolts (1/2 x 5 inches) through the engine mount bracket lower holes.
- Page 6 g013863 g013864 Figure 9 Figure 10 1. Hose guide 1. Hose guide Attach the hose guide to the battery tray tab Note: Two mounting bolts must be removed using 2 bolts (1/4 x 3/4 inch) and flange locknuts from the chassis rear wall to allow the hydraulic (Figure 10).
- Page 7 g013908 g259001 Figure 12 Figure 15 1. Hydraulic pump 2. Hydraulic hose #4 1. Return 2. Pressure On the SH version, model 44701, remove the If pressure and return hoses were previously fasteners securing the cover to the front of the installed at the locations shown in Figure 14 ProPass and set the cover aside...
- Page 8 g013948 Figure 19 g013866 Figure 17 1. Power harness 2. Intermediate wiring harness 1. Hose routing Tighten all of the hydraulic connections and fasteners. Refit the ProPass Twin Spinner assembly. Connect the black cable and the black pre-routed cable to the battery negative terminal and the white cable and the red pre-routed cable to the battery positive terminal.
- Page 9 1,005 cm ounces) of oil before starting. Check the level of oil Alternate fluids: If the Toro fluid is not available, other before the engine is first started and daily thereafter. petroleum-based Universal Tractor Hydraulic Fluids...
- Page 10 Filling the Fuel Tank Fuel Tank Capacity: 6.1 L (1.6 gallons) Recommended Fuel: • For best results, use only clean, fresh (less than 30 days old), unleaded gasoline with an octane rating of 87 or higher (R+M)/2 rating method). • Ethanol: Gasoline with up to 10% ethanol (gasohol) or 15% MTBE (methyl tertiary butyl ether) by volume is acceptable.
- Page 11 WARNING Battery terminals or metal tools could short against metal tractor components causing sparks. Sparks can cause the battery gasses to explode, resulting in personal injury. • When removing or installing the battery, do not allow the battery terminals to touch any metal parts of the tractor.
- Page 12 Notes:...
- Page 13 Notes:...
- Page 14 The method of transmission shall be electronic transmittal. This machinery shall not be put into service until incorporated into approved Toro models as indicated on the associated Declaration of Conformity and in accordance with all instructions, whereby it can be declared in conformity with all relevant Directives.
- Page 15 The Way Toro Uses Information Toro may use your personal information to process warranty claims, to contact you in the event of a product recall and for any other purpose which we tell you about. Toro may share your information with Toro's affiliates, dealers or other business partners in connection with any of these activities. We will not sell your personal information to any other company.
- Page 16 Countries Other than the United States or Canada Customers who have purchased Toro products exported from the United States or Canada should contact their Toro Distributor (Dealer) to obtain guarantee policies for your country, province, or state. If for any reason you are dissatisfied with your Distributor's service or have difficulty obtaining guarantee information, contact the Toro importer.