Toro ProPass 200 Operator's Manual page 28

Figure 44
Manual Override Decal
1. Floor speed adjustment
•
To adjust the spinner speed
a flat-head screwdriver to increase by turning
clockwise or decrease by turning counter
clockwise.
Note:
If adjusting with the hydraulic flow active,
ensure that the floor is turned off if you do not wish to
have sand being spread as you adjust.
Once your settings are acceptable, use the hydraulic
flow control on your tow vehicle to turn the system
on and off for operation.
decal119-6815
2. Spinner speed adjustment
(Figure 44), use
Key Functionality Elements
•
When you turn the handheld remote on, the
display should read FLR OFF and OPT OFF in
approximately 5 seconds. If the words "waiting for
base" are in the display, check to ensure there is
electrical power to the base unit and ensure the
E-S button on the base unit is out.
TOP
•
There is always a current working memory. This
is not the same as a preset. The last saved work
settings will be in the current working memory
when you turn the handheld remote on.
•
Operational sequence of the handheld remote
start buttons:
– Pressing a start button once (A
F S
LOOR TART
current working memory setting stored in the
handheld remote.
– By pressing the same start button a second
time, the component turns on if the hydraulics
are engaged (it shows numbers ramping up in
the display).
– Pressing the same start button a third time
will store the new setting established in the
remote's working memory.
•
After pressing a start button once to view the
current working memory setting in a non-working
mode, there is approximately 10 seconds to begin
adjusting the setting or the element will revert back
to off. In a working mode, the 10 second rule does
not apply.
•
To program a preset, you must have the elements
activated or engaged first.
•
To operate from a preset, the you must have
element speed percentages in the display to
activate or engage them. If the word OFF is in the
display, you must recall the preset.
28
S
LL
, or O S ) calls up the
PTION TART
,
TART