Mounting The Hopper To The Tow Chassis - Toro ProPass 200 Operator's Manual

Figure 12
Hopper extension kit installed
4
Mounting the Hopper to the
Tow Chassis
Tow Chassis Configuration Only
Parts needed for this procedure:
6 Bolt
6 Flange nut
Procedure
Note:
If you are mounting the ProPass top dresser
onto something other than the tow chassis, refer to
the installation instructions for your application.
1. Attach a lifting device to the lifting bracket bolted
inside the hopper assembly
g237533
(Figure 13).
12
Figure 13
1. Lifting bracket
WARNING
Do not attempt to lift the bed and hopper
with the Tow-Behind Chassis, ProGator,
Workman, or TDC Chassis connected.
The lifting bracket is not capable of lifting
the entire machine.
2. Using a lifting mechanism, position the hopper
over the tow chassis.
3. Line up the 6 mounting holes (3 per side) and
install the 5/16 x 1 inch bolts and flange nuts.
Figure 14
1. Mounting locations (3 each side)
4. Remove the lifting bracket from the hopper sides
and install the bolts to the hopper sides.
Note:
Retain the lifting bracket for future use;
do not discard it.
g013209
g013949