Wireless Controller Safety (Model 44751 Only); Disconnecting The Machine From A Tow Vehicle; Operating The Hydraulic Controls And Options - Toro ProPass 200 Operator's Manual

Note:
For wireless models the A
function can be used in place of the O
S and F
TART LOOR
operation start feature. The option will start
followed by the belt.
11. Travel in a straight line and spread the material
at a constant speed until the spread reaches the
edge of the top dressing area.
12. Turn off the conveyor belt, turn the machine
around, and position it for the next pass.
13. Before making the next pass, check the spread
pattern on the ground. Adjust the machine
settings if necessary.
14. Continue steps 10
requiring top dressing has been completed, or
the hopper is empty
15. Turn off the conveyor belt and the option,
lower the tow vehicle rpm, and disengage the
hydraulics.
Note:
Always shut the conveyor off first.
Wireless Controller Safety
(Model 44751 only)
The wireless controller activates rapidly rotating parts
and pinch hazards. Be sure to always be in line of
sight of the ProPass when operating, adjusting or
programming the wireless controller.
To ensure that the activation of the spinners and the
floor is intentional, you must press the start buttons
twice: once to select and once to engage. This
helps prevent accidental start when making manual
adjustments on the machine
If no buttons are pressed for 10 seconds when
programming or preparing to operate the wireless
controller, it will enter into an idle mode and resort
back to the last saved program or setting.
CAUTION
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
Power off your wireless controller and work
vehicle (to ensure no hydraulic flow) before
making any physical adjustments to the
blades or floor.
Disconnecting the Machine
from a Tow Vehicle
1. Park the tow vehicle and the machine on dry,
level ground.
S
LL TART
PTION
S functions as a single
TART
to 13 until the entire area
2. Engage the parking brake on the tow vehicle,
shut off the engine, and remove the key.
3. Place blocks under 2 wheels of the machine
(front and back).
4. Relieve the pressure from the hydraulic system.
5. Disconnect the hydraulic hoses, coil and store
them on the front of the machine.
6. Disconnect the intermediate power cord from
the tow vehicle.
7. Lower the jack stand(s) as follows:
•
On tow-behind chassis, turn the jack stand
90 degrees (clockwise) to the down position
to support the machine
•
On Truckster direct connect chassis, move
the jack stands to the front of the machine
and turn them 90 degrees until the bottom of
both jack stands points to the ground.
8. Lift the machine with the jack stand(s) until the
weight is off the tow-vehicle draw bar.
9. Pull out the hitch pin.
10. Ensure that there is no further connection
between the machine and the tow vehicle.
Operating the Hydraulic
Controls and Options
Remote Control System
The remote control system consists of a handheld
remote, a +12 to +14.4 VDC Base Unit, and a wiring
harness.
25