Toro ProPass 200 Operator's Manual page 2

This product contains a chemical or chemicals known to the State of California
This product complies with all relevant European directives, for details please see the separate product specific
Declaration of Conformity (DOC) sheet.
Electromagnetic Compatibility
Domestic: This device complies with FCC Rules Part 15.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference and (2) this device
must accept any interference that may be received, including
interference that may cause undesirable operation.
This equipment generates and uses radio frequency energy and
if not installed and used properly, in strict accordance with the
manufacturer's instructions, may cause interference to radio
and television reception. It has been type tested and found to
comply within the limits of a FCC Class B computing device in
accordance with the specifications in Subpart J of Part 15 of
FCC Rules, as stated above. However, there is no guarantee
that interference will not occur in a particular installation. If
this equipment does cause interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:Reorient the receiving
antenna, relocate the remote control receiver with respect to the
radio/TV antenna or plug the controller into a different outlet so
that the controller and radio/TV are on different branch circuits.If
necessary, the user should consult the dealer or an experienced
radio/television technician for additional suggestions.The
user may find the following booklet prepared by the Federal
Communications Commission helpful: "How to Identify and
Resolve Radio-TV Interference Problems". This booklet is
available from the U.S. Government Printing Office, Washington,
DC 20402. Stock No. 004-000-00345-4.
FCC ID: W7OMRF24J40MDME-Base,
OA3MRF24J40MA-Hand Held
IC: 7693A-24J40MDME-Base, 7693A-24J40MA-Hand Held
Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.
Japan Electromagnetic Compatibility Certification
Handheld:
RF2CAN:
Mexico Electromagnetic Compatibility Certification
Handheld:
RF2CAN:
© 2017—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
to cause cancer, birth defects, or reproductive harm.
WARNING
CALIFORNIA
Korea Electromagnetic Compatibility Certification(Decal
provided in separate kit)
Handheld:
RF2CAN:
Singapore Electromagnetic Compatibility Certification
Handheld: TWM240008_IDA_N4023-15
RF2CAN: TWM-240005_IDA_N4024-15
Morocco Electromagnetic Compatibility Certification
AGREE PAR L'ANRT MAROC
NUMERO d'agrement:
Delivre d'agrement::
Introduction
This machine is intended to be used by professional,
hired operators in commercial applications. It is
designed primarily for metering and dispersing
materials, under a range of moisture conditions,
without clogging or drastically affecting the dispersion.
Important:
and proper operation of this machine, carefully
read and fully understand the contents of this
Operator's Manual. Failing to follow these
operating instructions or to receive proper
training may result in injury. For more information
on safe operating practices, including safety tips
and training materials, go to www.Toro.com.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready.
identifies the location of the model and serial numbers
2
MR 14078 ANRT 2017
29/05/2017
To maximize the safety, performance,
Contact us at www.Toro.com.
Figure 1
Printed in the USA
All Rights Reserved